Electronic repairs, Automation and electronic design to keep your machinery running

Automation

Industrial automation and PLC programming

A line that needs an extra station. A machine that runs, but that nobody dares to touch any more. A program from a machine builder that no longer exists. That is work for which you need someone who writes the program and can also measure the electronics underneath it.

Industrial installation with pipework and an electric motor

What we take on

From new control software to the program nobody understands any more

Writing new control software

The complete control of a machine or line: PLC program, HMI screens, commissioning and documentation. You receive the source code and the documentation — you are not left hostage to your programmer.

Extending an existing installation

An extra station in a line that is already running, a machine that gets a new function, an outdated component that needs replacing. The difficult part is not the new piece, but not breaking what is already there.

Takeover and debugging

A program you inherited from a machine builder that no longer exists, or one that has been modified so often that nobody can see the logic any more. We get to grips with it, document what is there, and fix what goes wrong.

Analysis with a written report

Something is going wrong and nobody can work out why? We measure and write down what we find: the faults identified, the cause and the recommended action. Useful for justifying the work to your client or your management.

The difference

Why your PLC is better programmed by someone who repairs electronics

When a drive goes into fault, the programmer points to the hardware and the electrician to the program. Days are lost that way, and neither of them is wrong.

The usual course of events

Two parties, one problem

The automation engineer reads the code, sees nothing wrong and says the drive is faulty. The maintenance department replaces the drive, and the same fault comes back.

What was really going on — a voltage dip, poor shielding, a communication cable that is at its limit — nobody finds, because nobody looks there.

With us

Both sides at once

We read the program and put the scope on the power supply. We measure the bus communication and know how an inverter works on the inside, because we have one on the workbench every week.

That makes the search shorter. And it makes the answer more honest: sometimes the conclusion is that there is nothing wrong with the control system.

Platforms

What we have worked with

We only list what we have actually had in our hands, and we distinguish between what we wrote ourselves and what we took over. That saves you a disappointment later.

Written ourselves

Large, complete programs from scratch: Mitsubishi FX5, Wago, and currently a large project on Siemens S7 with WinCC.

Taken over and debugged

Existing CODESYS applications: faults in retentive variables, RTC initialisation and screen behaviour traced and fixed.

Analysed and reported

Installations on S7-300 with PROFIBUS, drives of the SINAMICS G120 type and operator interfaces in WinCC flexible: measured, faults documented, report delivered.

And what we have not done yet

If you ask about a platform or a fieldbus we have not used yet, we tell you so up front — and whether we are willing to take it on. We learn fast, but not at your expense.

How we work

On a project basis, with a price up front

You pay the agreed price

You receive a quotation in advance, and that price applies. No subscription, no minimum order, no maintenance contract you did not ask for.

For machine builders: under your name

We deliver to you and do not communicate with your customer unless you ask us to. You remain the contractor.

The source code is yours

Program and documentation are handed over. A future modification does not have to be done by us.

From a single day to a large project

A diagnosis that has stalled is a job in its own right. For large projects we expand the team with established specialists and partner companies.

Contact

Tell us what needs to be done

An initial conversation costs you nothing. If you have schematics, a program printout or error codes, feel free to send them along — then we can tell you straight away whether the work is right for us.

Marpat bv · Ondernemingenstraat 3, office 2 · 8630 Veurne
+32 471 933 441 · info@marpat.be